5 Ways to Paint Your Room’s Walls

Paint Your Room's Walls

Are you among those who take pleasure in redecorating a room every few years? You might buy the most recent colour trend (or classic paint colour) on a whim and then pick up your roller to apply the first coat. Wait a minute. You’re omitting one or two essential steps. In this piece, we have rounded up some of the best approaches that can assist you in painting your walls. Make sure to use quality colours for painting. Below are the 5 ways to paint your room’s walls to get the best appearance. 

Ways to Paint Your Room’s Walls

  • Sanitise the walls, and Trim, windows, and doorframes should be taped

You’d be nonplus how much grime can get lodged in a fresh time coat of the paint, but mostly people skip this step to save time. With water, a little light dishwashing soap, and a cellulose sponge, remove dust, filth, and grease stains (which can destroy a flawless finish). Clean walls with water to get rid of soap residue. Fill nail holes with spackling paste after the walls have dried, then lightly sand them.

Use blue painter’s tape, which can be used up to a week in advance when you’re going to paint your room’s walls. To avoid peeling off paint with the tape, remove it immediately after painting and before the wall dries. Once they master cutting in with a brush, some folks altogether skip this phase. However, missing this step before you’re prepared or applying the tape too quickly, which could leave covering gaps, can also be costly mistakes

  • Prime them 

It’s a widespread misconception that walls that have been painted previously don’t require priming. However, a fresh priming layer increases the paint’s shine and coverage and makes the finish coat appear more consistent. Moreover, you can shop for the best paint colours using the best discount codes, which can help you save money without compromising quality. Priming the walls may give your walls the layer it needs to be more consistent. 

  • Brush challenging areas before rolling

Use a two-inch angled brush to coat around trim and in wall bends where your roller can’t range. Leave two to three inches between you and the mouldings, doors, and windows in the process of painting your room’s walls. This step must be completed before rolling to prevent glaring brush strokes at the margins. This phase can be difficult, and you’re not the only one, and it takes time to master the art of cutting in with paint.

  • Utilize the W method when rolling

Start rolling on a three-by-three-foot W pattern in the corner of a wall to maximise efficiency, then fill it in without uplifting the comber. Section by section, continue till you’re done. This method aids in preventing noticeable roller marks. Furthermore, it gives the best colour appearance to your walls. One wall at a time should be painted for the evenest coverage.

  • The Trim gets painted last

You should always paint the trim last since it is more probable that you will leak wall paint on it than get wall paint on the trim. Tape where the trim meets the wall once the walls are fully dry. Next, use a two-inch angled brush to paint the mouldings, door, and window frames. In addition to using a drop cloth, you should also use a paint guide to protect your floors. 

Last Words

So that now you know the 5 ways or steps to paint your room’s walls. Make sure to follow the steps so you won’t have any crucial things during the process. Painting your wall requires focus and basic skills everyone can acquire. Quality paint colours can give your walls an amazing look and last a long time. A good paint colour endures all types of weather and gives the feeling of a new appearance for a long time. So, make to go after the above-mentioned steps to get the best colour appearance for your room’s wall. 

Leave a Reply

Your email address will not be published. Required fields are marked *